All about dyne pens

Dyne pens are something that helps you check the surface tension of the substance you wish to get printed. A measure of surface energy is what the usage of the dyne level depends. Higher the dyne level at the surface, the better does it get equipped to glues and paints. To calculate the dyne levels on the surface, the dyne-technology pens were designed to mark the surface tension level efficiently and reasonably. For promoting adhesion, the surface needs to be treated with corona or plasma to get a good wetting over the surface of the substrate. Obtaining high surface energy is a must when you want to print, glue, or coat the substrates. Mapping the contact angle or usage of the surface energy test pens helps you to ascertain the surface energy.

The dyne levels are different for different surfaces, such as dyne levels on the silicone sleeve differs from that on the PVC, so are needed to test with varying suggested treat levels.

 

Benefits of dyne pens

Caring for production safety standards is the principal priority of all businesses. Dyne pens eliminate the long quality-checking process by reviewing the wetness of the surface and promptly learn whether it is fit for printing or coating.

Dyne pens render the following benefits:

Scraping

The process of checking the printing on materials results in a lot of scrap production. Dyne pens help in eliminating this as they help to check the surface efficiently, without needing to scrap the materials.

A quick result time

The quickness with which you can check the results save lots of time. Dyne pens render results merely in four seconds; all you need to do is draw a line with the pen on the surface you want to check.

Reliability

In addition to a swift source of getting the decision, it is also a reliable and accurate method for verifying the treat levels.

Affordable

Purchasing a dyne pen won’t cost you much. Moreover, they help in eliminating the scrap generation, which further helps in cutting down the cost.

Usage

A person learned about Polypropylene, and Polyethylene treatments can perform the tests and can judge results, without even utilizing any other equipment or machines.

Pen Test Procedure

After learning about the benefits of dyne pens, let us now learn about its usage:

• Taking off the cap, depress the tip slightly onto the clean surface.
• Examine the solution after applying it nearly to a square inch area.
• Try to understand the behaviour of the applied solution. Note down the course when the droplets befall, or peripheral shrinkage occurs.
• If the solution breaks into droplets in less than four seconds, repeat it with the lower surface tension. If the peripheral shrinkage does not happen after four seconds, repeat the test with the next higher surface tension.
• Make sure to not repeat the test in the same area again.
• Repeat the above steps until the correct dyne level gets concluded. A suitable dyne level gets achieved when the surface can hold the solution precisely for four seconds before the peripheral shrinkage, or droplets begin to occur.
• The guidelines suggest the surface coverage be near to ten dynes higher than the ink, coating or adhesive, though it may not be valid for every application.

More about Dyne Pens

Excessive usage of the solution may result in a false reading. The pens can be used for 6-12 months, and are needed to store at room temperature. Make sure to apply a consistent, but normal pressure on the surface while employing it. Direct exposure to light or keeping them unsealed when not in use, modifies the dyne levels in pen. A well-cleaned surface before using the solution should be a guarantee for more reliable results.

Getting the dyne pens

Searching for reliable dyne pens is no more hassle. Ice-equipment.com is where you can order these pens and also browse from a range of other products. So what keeps you waiting? Contact us today and allow the company to serve you.